Suzhou Electric Appliance Research Institute
期刊號: CN32-1800/TM| ISSN1007-3175

Article retrieval

文章檢索

首頁 >> 文章檢索 >> 往年索引

計及分布式電源的配電網電容器定容選址

來源:電工電氣發布時間:2016-04-06 14:06 瀏覽次數:15

計及分布式電源的配電網電容器定容選址 

劉子俊1,孫健2

1 南京理工大學 自動化學院,江蘇 南京 210094;2 江蘇省電力公司電力科學研究院,江蘇 南京 211103 
 

摘 要:針對含風電機組的配電網,提出了一種基于ETAP軟件的電容器定容選址優化方法,該方法利用遺傳算法求解線性規劃問題。在仿真過程中將DG視為負荷,提出一種長時間尺度上的“無功靜態控制”,實現動態與靜態相結合的無功優化,經ETAP仿真計算后,結果顯示:所有母線電壓得到補償;在規劃期間由于無功損耗的減少使支路輸電容量增加并帶來了一定的收益,整個配網系統經濟效益達到最佳;對于含風電機組的配電網,其無功優化效果更加明顯。
關鍵詞:分布式電源;無功補償;線性規劃;定容選址
中圖分類號:TM76 文獻標識碼:A 文章編號:1007-3175(2014)10-0015-04


Capacitor Capacity Setting and Location Selection for Distribution Network with Distributed Power 

LIU Zi-jun1, SUN Jian2 
1 Institute of Automation, Nanjing University of Science and Technology , Nanjing 210094,China; 
2 Jiangsu Electric Power Company Research Institute, Nanjing 211103, China
 
 

Abstract: Aiming at the distribution network with wind turbines, this paper raised an optimizing method based on ETAP software for capacitor capacity setting and location selection. This method used the genetic algorithm to solve linear planning issues. In the simulation process the distributed power was regarded as load. A long time scale of “reactive static control” was raised to realize dynamic and static combined reactive optimization. The result of ETAP software simulation calculation shows that all the bus bar voltage is compensated, in planning period, due to the reduction of reactive power, the branch power transmission capacity increased, bringing a certain gain, the whole distribution network system economic reaches the best, especially for the distribution network with wind turbines, and its reactive optimization effect is more obvious.
             Key words: distributed power; reactive compensation; linear planning; capacity setting and location selection


參考文獻
[1] 陳琳,鐘金,倪以信.含分布式發電的配電網無功優化[J].電力系統自動化,2006,30(14):20-24.
[2] 劉健,閻昆,程紅麗.樹狀配電線路并聯電容器無功優化規劃[J].電網技術,2006,30(18):81-84.
[3] 陳旺虎,陳奇志,古樹平.配電網潮流前推回代法的一種簡單實現方法[J].江蘇電機工程,2010,29(4):45-47.
[4] 陳海焱.含分布式發電的電力系統分析方法研究[D].武漢:華中科技大學,2008.
[5] 郭力,王成山.含多種分布式電源的微網動態仿真[J].電力系統自動化,2009,33(2):82-86.
[6] 萬立勇,譚興,肖輝,等.計及分布式電源的配電網無功潮流優化研究[J].電測與儀表,2011,48(8):10-14.
[7] 何仰贊,溫增銀.電力系統分析[M].武漢:華中科技大學出版社,2002.
[8] 嚴干貴,王茂春,穆鋼,等.雙饋異步風力發電機組聯網運行建模及其無功靜態調節能力研究[J].電工技術學報,2008,23(7):98-104.