Suzhou Electric Appliance Research Institute
期刊號: CN32-1800/TM| ISSN1007-3175

Article retrieval

文章檢索

首頁 >> 文章檢索 >> 往年索引

萬能式斷路器防彈跳裝置與控制器配合的分析研究

來源:電工電氣發布時間:2023-12-28 11:28 瀏覽次數:188

萬能式斷路器防彈跳裝置與控制器配合的分析研究

蔡元?dú)J,陳佳超
(上海森立電氣有限公司,上海 200444)
 
    摘 要:在斷路器的各個部件中,機構部件對于多項性能指標具有重要作用。運用 ADAMS 仿真軟件對 HTW65 萬能式斷路器出現故障后機構再合閘瞬分的現象進行仿真研究,發現了產生機構合閘瞬分的原因是機構的復位反彈時間小于控制器的磁通信號釋放時間, 造成二次合閘瞬分的現象。提出了有效的改進方案,并對改進后制作的樣機進行了試驗驗證,結果表明改進方案有效解決了故障后機構再合閘瞬分的問題。
    關鍵詞: 萬能式斷路器;防彈跳裝置;控制器;彈跳時間
    中圖分類號:TM561     文獻標識碼:B     文章編號:1007-3175(2023)12-0059-05
 
Analysis and Research on the Coordination of Anti-Bounce Device and
Controller of Universal Circuit Breakers
 
CAI Yuan-qin, CHEN Jia-chao
(Shanghai Senli Electric Co., Ltd, Shanghai 200444, China)
 
    Abstract: Among all the parts of circuit breakers, the mechanism part plays an important role in a number of performance indexes. The simulation software ADAMS is used to simulate the mechanism re-closing instant breaking of HTW65 universal circuit breaker after the failure occurs to it. According to the simulation, the cause of the mechanism closing instant breaking is that the reset rebound time of the mechanism is less than the release time of the controller flux signal, which leads to the phenomenon of re-closing instant breaking. An effective improvement scheme is proposed, and the improved prototype is tested and verified. The results show that the improved scheme effectively solves the problem of mechanism re-closing instant breaking after the failure occurs.
    Key words: universal circuit breaker; anti-bounce device; controller; bounce time
 
參考文獻
[1] 尹天文. 低壓電器技術手冊[M] . 北京:機械工業出版社,2014.
[2] 胡正勇, 吳翊, 彭翔, 等. 萬能式斷路器防彈跳裝置失效的仿真分析及改進[J] . 低壓電器,2011(14) :5-9.
[3] 張懷亮. 萬能式斷路器抗沖擊和防回彈問題研究[J].低壓電器,2013(12) :5-7.
[4] 任山波,李惠敏,卜浩民. 萬能式斷路器動觸頭防回彈技術研究[J]. 低壓電器,2018(14) :27-32.
[5] 陳德桂,李興文. 低壓斷路器的虛擬樣機技術[M].北京:機械工業出版社,2009.