旁路代路操作及常見故障分析 

李繼光，蔣國順 
(廣東電網有限責任公司佛山供電局，廣東 佛山 528000) 
 

摘 要： 建立了220 kV 變電站典型模型，介紹了旁路代線路開關和旁路代主變變高開關的操作過程、注意事項及常見故障。指出旁路代路的主要過程為保護定值的整定及對旁路母線充電、代開關操作等，而代主變開關時，二次操作與一次操作配合必須緊密，否則將引起事故。
關鍵詞： 旁路開關；旁路母線充電；CT 切換；PT 非正常并列
中圖分類號：TM645.2+4 文獻標識碼：B 文章編號：1007-3175(2015)03-0038-03

Analysis on Operation Process and Common Faults of Bypass Switch 

LI Ji-guang, JIANG Guo-shun 
（Foshan Power Supply Bureau, Guangdong Power Grid Co., Ltd, Foshan 528000, China） 
 

Abstract: The 220 kV typical substation model was established. Introduction was made to the operation process, matters needing attention and common fault when the bypass switch replaced the switching of line or the main transformer high switch. The main process of bypass switch replaced line is to protect the setting value, the bypass bus charging, switch replaced operation. When the bypass switch replaced the switching of the main transformer switch, the secondary electrical operation must match up the primary electrical operation closely, otherwise faults will take place.
Key words: bypass switch; bypass bus charging; CT transforming; PT abnormal juxtaposition

參考文獻
[1] 中國南方電網有限責任公司.電氣操作導則[S].廣州：中國南方電網有限責任公司，2004.
[2] 陳海亮.旁路開關代路操作方法的分析[J].電工技術，2008(8)：77-79.
[3] 曾子縣.220 kV光纖縱聯保護中旁路保護代線路保護的若干問題[J].廣東電力，2011，24(8)：44-46.
[4] 屈世民，李錦錦. 基于雙套大差動保護的220 kV 主變代路新方法[J]. 電力系統保護與控制，2011，39(6)：144-146.