塑殼斷路器操作機構一種失效模式分析

 

時培欣

（伊頓電氣有限公司，江蘇 蘇州 215121）

 

    摘 要：針對塑殼斷路器合閘狀態，對操作機構進行受力分析，確定鎖扣的力矩平衡關系，明確跳扣和鎖扣的解鎖條件，并分析了動觸頭斥開后鎖扣力矩變化情況。提出在斷路器設計過程中，對機構彈簧力值優化，跳扣和一次鎖扣搭接處角度優化，跳扣邊緣增加倒角，解決了產品在動觸頭被斥開并鎖止在一定位置，跳扣和一次鎖扣無法解鎖的問題。

    關鍵詞：塑殼斷路器；操作機構；失效模式；解鎖

    中圖分類號：TM561     文獻標識碼：B     文章編號：1007-3175(2018)03-0060-02

    Abstract: Aiming at the on-position of moulded case circuit breaker, this paper analyzed the force of operation mechanism, determined the torque balance relation of latch and cleared the unlocking condition of cradle and latch, analyzing the change of the latch torque after the moving arm was blown off. This paper proposed to optimize the mechanism spring force and the junction corner connecting primary tripping latch to locking latch in the process of circuit breaker design. The margin of tripping latch was added a chamfer to solve the problem that the moving contact of product was repelled and locked up in certain position, unable to unlock tripping latch and primary locking latch.

    Key words: moulded case circuit breaker; operation mechanism; failure mode; unlocking